- What happens if you cut a cable line?
- How much wire do I need for a 2000 square foot house?
- Does Comcast run cable lines?
- Are rg6 and rg11 connectors the same?
- Does length of coax affect signal?
- How much does Comcast charge to run a line?
- How is cable run calculated?
- How far can you run a cable line?
- Does Internet and cable use the same line?
- Are all coaxial cables the same?
- Can I run my own cable line?
- How deep should a cable line be buried?
- What is cable run?
What happens if you cut a cable line?
If it is a drop and isn’t going to your house, it is most likely trespassing your property and you can request it be moved.
So long story short, they can charge you and most likely will if they feel you did it on purpose.
A cable company most likely would just replace the cable..
How much wire do I need for a 2000 square foot house?
Costs also vary by area, as some electricians will charge per hour while others charge by the job. On average, the cost to wire a home is around $4 per square foot. Therefore, to rewire a 2,000 square foot home, the total cost would be about $8,000.
Does Comcast run cable lines?
An underground cable line normally brings Xfinity services to your home. In most cases, these lines are installed when your home’s being built; however, in some instances, the line may not have been installed, or it could be damaged and need to be replaced.
Are rg6 and rg11 connectors the same?
Both the RG6 and RG11 cables are 75-ohm cables that make use of F-type connectors. RG11 has a greater and longer range longer than the R6. To be more specific, the RG6 tops out at 50 feet before the total signal loss. The RG11 does better with more than 50 feet to about 10 feet.
Does length of coax affect signal?
When it comes to signal loss over longer cable lengths, the basic rule of thumb is that a 50-foot cable can experience noticeable signal loss, and a 100-foot cable can drop as much as one-third of the original signal.
How much does Comcast charge to run a line?
Based on our tests, signing up for standalone Internet or TV service on Comcast.com often requires payment of a $59.99 or $89.99 installation fee, depending on where you live.
How is cable run calculated?
Calculating Cable Lengths(AL) = (A + B)/2. Add SLACK (S) of minimum 0.9 m (36 in) at the Distribution Device plus a minimum of 0.2 mm (8 in) of excess cable at the outlet.(S) = 0.9 m (36 in) + 0.2 m (8 in) = 1.1 m (44 in) … (D) = 4.5 m (15 ft) … (TACL) = AL + S + D.
How far can you run a cable line?
Coaxial cable can be cabled over longer distances than twisted-pair cable. For example, Ethernet can run approximately 100 meters (328 feet) using twisted-pair cabling. Using coaxial cable increases this distance to 500m (1640.4 feet).
Does Internet and cable use the same line?
Cable internet runs on the same copper coaxial cable lines that deliver cable TV to your house, so it’s available in most areas that support cable TV service. A cable internet modem usually delivers faster internet than DSL.
Are all coaxial cables the same?
Not all coaxial cables are the same. There are so many types and variants to choose from. It differs from the mechanical, electrical, construction, and environmental specifications. All cable varies it sizes, shielding, attenuation, and the amount of power it can handle.
Can I run my own cable line?
However, for now, all you need to know is that your telephone, TV, Internet and other communication needs can all be handled by running only two types of cable—all headquartered in a central distribution system you can install yourself. … Existing phone lines and jacks can coexist with your new system.
How deep should a cable line be buried?
24 inchesDirect Burial Installation The minimum depth requirement of a direct burial cable is 24 inches, except when installed under a concrete slab with a minimum thickness of 2 inches. In this case, the cable can be installed at only 18 inches deep.
What is cable run?
Cable Run is a length of installed cable connecting two network components that are not in immediate proximity to one another. … Horizontal cable: Runs through building plenums (the space between the floor and the ceiling) and false ceilings, connecting wiring closets together and connecting patch panels to wall plates.